Construction Consumables and Fixings You Reorder Every Month

Consumables are the items a site uses up rather than installs and leaves behind: fixings and fasteners, screws and bolts, tapes and adhesives, marking products and general hardware. They are bought repeatedly in small quantities. The defining feature is the reorder rhythm rather than the product type, which is why a standing order works better than ad hoc buying.

The range covers construction fixings including concrete screwbolts and general fasteners suited to slab and wall applications. Selection depends on the substrate, the load and the embedment depth. Check the listing for the fixing type and size, and match the drill diameter to the fixing rather than using the nearest bit available.

A concrete screwbolt anchors directly into concrete without a separate plug, so it suits base plates, brackets, frames and fixtures fixed to a slab or wall. It is a removable fixing, which makes it useful where something may need to come off again. Match the diameter and length to the load and the embedment depth required.

Count the fixing points first, then add a working allowance for wastage, damaged threads and lost items. Fixings are lost more often than they fail, so a strict count leaves a job short. For repeated work, work out the consumption per unit and order to that rate rather than to the drawing.

Pack sizes vary by product, and the listing states what quantity you receive. Consumables are generally supplied in packs sized for site use rather than as singles. Choose the pack that matches roughly a month of consumption on your site, because an oversized pack tends to disappear into a container and an undersized one means constant reordering.

Fixings, marking paint, tape and blades, in that order on most sites. All of them are cheap individually, used constantly, and rarely tracked by anyone. That combination is why they run out mid-task rather than between tasks. Setting a minimum level for each is more effective than trying to forecast exact usage.

Yes, and it is the point of the range. Trade account holders can use the B2B portal with CSV upload ordering and multiple user roles, so a prepared reorder list becomes an order without retyping. Set minimum levels, order to those levels, and review against actual consumption every few months rather than annually.

Suitability depends on the specific product and the application. Where a fixing carries a structural load, order to the engineer's specification rather than substituting a general purpose fastener, and confirm the published capacity for the substrate you are fixing into. If the specification is unclear, ask before ordering rather than after installation.

Yes. Tapes and marking products sit in the consumables range alongside the fixings, and they are among the fastest moving lines on most sites. Marking paint for set-out and tape for bundling and labelling are the two that disappear quickest. Check the current range on the site, because these lines move faster than construction stock.

Standard consumable lines ordered before the daily cut-off dispatch the same day, then travel by the freight service that suits the destination. That timing is deliberate, because a missing box of fixings can stop a trade for a full day. Pick-up from Bankstown is available for anything needed the same shift.